The Bittoba flowmeter is the only type of flowmeter with sensors for multiple media. It can be used for a wide range of gas, steam and liquid flow measurements. Gases: primary air velocity (volume), secondary air velocity (volume), (negative pressure) air, oxygen, hydrogen, dry gas, converter gas, blast furnace gas, producer gas, coke oven gas, natural gas, liquefied gas, flue gas, Chemical materials such as gas; steam: superheated steam, saturated steam, wet steam, dry steam, two-way steam and so on. Liquids: water, water, oil, oil, lean oil, light oil, tar, heavy oil, crude oil, corrosive liquids, various solutions, chemical liquids, paraffin, etc. Pitobar flowmeters have the following features:
1. High precision:
Accuracy is 0.2% in range of 3% to 100%.
2. Energy saving:
A measuring element Pittoba sensor is made of Φ 20 ~ Φ 50 stainless steel, the cross-sectional area is very small, almost no pressure loss in the medium pipeline, so that the running cost is greatly reduced, compared with the orifice plate and other throttling devices are obvious energy saving effect.
3. Easy to install:
Simply place a comparable hole in the appropriate part of the pipe and insert the primary element pittopa into the center of the pipe to install it easily.
4. No maintenance:
A measuring element Bitowa itself does not require maintenance, simply by measuring the zero pressure and the full-scale test of the differential pressure transmitter as required by the periodic verification of the measuring instrument and the corresponding current input from the secondary meter.
5. Wide measurement flow range:
With a gas flow rate of 4 m/s or more, media with a flow rate of 0.2 m/s or more can be accurately measured. For low flow rate, small flow, large diameter measurement is particularly good.
6. Wide application range of media pipe cross-section shape:
The flowmeter has no requirement for the geometry of the cross-section of the medium pipe. Circular, elliptical, rectangular, square, prismatic, triangular, trapezoidal, etc. are all suitable.
7. High reliability:
Due to the very simple structure of the Pittoba sensor and reasonable structural design, the medium in the pressure guiding tube does not flow, and debris cannot enter easily, so the measurement accuracy can be maintained for a long time.
8. High temperature and high pressure:
Can withstand the highest temperature of medium 650 °C, spraying Al2O3 coating can withstand the maximum temperature of 1300 °C, maximum pressure of media resistant 32MPa.
9. No direct pipe section is required:
Tsinghua University's blowing experiments for decades have accumulated a correction coefficient database between pipe sections up to 15 times diameter under various conditions. As long as users provide straight pipe lengths, they can simulate field conditions in the wind tunnel laboratory and select Corresponding data calculation model to ensure measurement accuracy.
10. With intelligent secondary instrument:
It can display all parameters and remote communication to form a network for easy centralized management.
11. Online installation and overhaul:
Some non-stop-installed measuring points and media with excessive impurity content may not be discontinued for on-line installation measurements, and may not be discontinued for cleaning and maintenance.
The Bittoba flowmeter is the most advanced flow measurement instrument at home and abroad. The foreign instrument company has published and approved the Ventura flowmeter on the website.