It is reported that Dongfeng ABS has been researched and developed to the D generation, and has experienced many trials such as winter cold area test, mountain test, reliability test, EMC test, high and low temperature test, etc.; matching Dongfeng commercial vehicle, Yutong bus, Beiqi Futian Auman, Ankai Passenger cars, Chongqing Hongyan and other models; ABS control performance has reached the international advanced performance level of similar products, and has a certain degree of adaptability; diagnostic equipment has developed a series of diagnostic standards in line with the latest international standards, and with foreign products Compatibility, resulting in lower use costs.
At present, China's auto market, like international mature markets, has taken the development direction of parts and components companies to improve vehicle safety, stability, comfort, environmental protection, energy conservation, and electronic control. China's "Eleventh Five-Year" automotive industry development plan will encourage component companies to develop their own products in electronic products, brake systems, sensors, fuel injection systems, and active and passive safety systems. This gave the component manufacturers a new opportunity for independent research and development.
Silicone mould is a special mold for making crafts. According to performance, the raw materials of glue can be divided into ordinary silicone and weather silicone. The characteristics of silicone are high temperature resistance, corrosion resistance, strong tear resistance, high simulation precision, and it is used to make various handicrafts mold.
Mold should be made in time after the silicone is matched. Pour the glue on the highest part of the mold in a trickle, let it flow naturally, brush it in place with an oil paintbrush where the flow is not in place, if it is a piece of silicone, not only fill the entire product, but also brush the glue evenly. Each product should be brushed with at least three layers of silicone. The thickness of each layer of silicone is 1mm. In the process of brushing the silicone, each layer is required to be cured before the other layer can be brushed. When brushing the third layer, add one layer on top of the second layer. The thickness of the silica gel part of the whole mold is controlled in 3-4mm according to the different requirements of the size of the product, and the width is not greater than 60 mm of the product width. The time for the silicone to set is 20 minutes.
Silicone Injection Molding, Moulding Silicone, Rubber Molds, Rubber Mold Making
Sung Precision Mould & Plastic Co., Ltd. , https://www.injectionmoldingfactorys.com