At present, mining development is relatively hot, and skilled workers are relatively scarce. Many of them have not been formally trained and have been employed, which has caused huge economic losses to mining enterprises. In addition, the operation of grinding is a practical experience in production, and many engineers and technicians are not very clear, and the technical experience in this area cannot be found in various books. To this end, according to the author's years of experience in production and commissioning guidance and the combination of theoretical and technical, the grinding operation is elaborated.
As a ball miller operation, the factors that need to be adjusted without relative adjustment are: raw ore hardness, crushing particle size, grid sieve hole, ball mill model, steel ball mass, steel ball addition amount, steel ball size ratio, ball mill speed, classifier speed The distance between the impeller of the classifier, the height of the spindle of the classifier, the wear of the classifier blade, the overflow of the classifier, the height of the opening under the classifier, the opening size under the classifier, the opening height on the classifier, and the opening size on the classifier. This part of the factors is the early stage of design and process. Of course, now many unreasonable beneficiation plant design, equipment installation problems or equipment quality. This part of the factors are now explained.
Ball mill model selection: Different ball mill models can meet different process technology requirements. This factor must be reasonably selected during design. See the selection and calculation of the ball mill.
The ball mill is equipped with different cores, and the gears of the large and small gears have deviations.
The gear of the gear reducer of the ball mill has sand holes, and the equipment is installed, and there are still several classes, gear wear and other problems.
The following focuses on the important parameters of the daily adjustment of the ball mill, which is also an important content that directly reflects the level of ball mill operation and the utilization rate of grinding. Mainly: the size of the water supply of the ball mill, the size of the flushing at the discharge port of the ball mill, and the size of the ore.
There are several aspects that can be noticed for the aura of the ball mill. One is to see if the ball mill gives the mine mouth, and the other is to listen to the ball mill sound. If the ball mill is swollen, the sound becomes small and stuffy. The third is to watch the ball mill current. The control cabinet, in particular, emphasizes that if the ball mill is swollen, its current value becomes smaller, and many operators and engineers think that it is just the opposite. They think that the ball mill is swollen because the amount of mineral in the ball mill is large, and its current value is changed. Big, this is the wrong view. The principle is: the ball mill is swollen, because the amount of minerals in the ball mill is more, and when the ball mill has more ore, the steel ball and ore are operated together with the barrel of the ball mill, and the ore size of the ball mill discharge port becomes thicker. At this time, the ball mill does less work, and the electric energy is converted into kinetic energy, and the electric energy is correspondingly smaller. When the voltage is constant, the electric energy becomes smaller, and the change is caused by the current value becoming smaller.
Cold Chamber Die Casting
In the die casting industry, according to the difference of equipment, it can usually be divided into cold chamber die casting and Hot Chamber Die Casting. Cold chamber die casting is most used in aluminum alloy die casting. Cold chamber die casting is suitable for die casting of various non-ferrous metals, and its models are relatively complete, and the die castings of large and small parts are more suitable for production; the production operation is relatively simple, the production efficiency is high, and it is easy to automate. At present, the most used in the industry is also cold chamber die casting.
SCZY provides one-stop services such as mold development, die-casting production, product follow-up CNC machining, and product surface treatment. We have our own precision mold workshop, die-casting production workshop, and follow-up precision CNC workshop, which can ensure delivery and quality at the same time. It also provides outsourced surface treatment services, so that customers can have no worries.
Cold Chamber Die Casting, Die Casting Aluminum, Alu Die Casting, Custom Die Casting,Cold Chamber Die Casting Process
Shenzhen SCZY Technology Co.,Ltd , https://www.szsczycasting.com