How to install and maintain the security inspection machine?

The power supply of the security equipment must be well grounded. To prevent leakage, connect the leakage protector before connecting the power supply. And X-ray security inspection machine installation environment should be dry and ventilated, if the environment should be wet and waterproof measures to extend the life of the machine.

Any commissioning and maintenance of the security inspection machine must be performed by professional and technical personnel. It is not allowed to modify or add any accessories without permission.

Security inspection machine operation

Before the system is powered on, the lead curtain used to prevent X-ray leakage at the entrance and exit of the channel must be inspected. If it is damaged, it must be replaced immediately.

Before use, check whether the housing panel, display, keyboard, and cables of the equipment are damaged, and whether the machine is placed in a stable manner, and then check whether the drum runs smoothly.

Check if the conveyor belt is in good condition and the machine's LCD screen is forbidden from scratching or hitting with sharp hard objects.

Do not stand or sit on the conveyor while the belt is running. Do not touch the edges of the belt and the rollers on both sides with your hand. When the conveyor belt does not go or stops when it is traveling, it is necessary to immediately check whether the drum and the conveyor belt have slipped or stuck. Otherwise, the drum motor will be burned.

When the X-ray lamp is on, no part of the body can enter the examination room.

When the environmental temperature of the security inspection machine is lower than 5 degrees Celsius, it should be warmed up 30 minutes in advance. Before the baggage passes through, the water stains and ice cubes on the baggage shall be cleared.