It is a hassle to drive a car without electricity. The most economical way is to call for help. However, for some experienced old drivers, the following methods can be used for emergency response.
If you have a co-driver or a good-natured driver, you will certainly need to take a wire. You can use a battery-powered method to start the vehicle.
1 clip the two poles of the battery of the tram with the clips of the cable (the positive and negative poles must be careful not to make mistakes);
2 the same method to connect the electrode of another car;
3 Turn off all electrical equipment on the vehicle and start the vehicle where the battery providing the power source is located. Let the engine run for a few minutes to ensure sufficient power.
4 Then start the electric vehicle in the normal way. After starting, lightly step on the accelerator pedal to make the engine run at 2000r/min for several minutes.
5 Close the ignition switch of the two vehicles. Carefully remove the cables. Avoid touching the positive and negative cable Connectors.
Starting the cart is a relatively common emergency starting method. However, this is an indispensable means and cannot be used frequently. This has some damage to the engine and the clutch. The automatic transmission cannot be started by this method.
Before starting the cart, it is necessary to observe whether the road condition of the vehicle parking position is suitable for the start of the cart, and it is possible to use the downhill road to increase the speed of the vehicle; try not to start the cart on the sections where the number of vehicles and pedestrians is large, so as to avoid accidents caused by improper driver's response after the vehicle starts.
The ignition should be turned on before the vehicle is propelled. After reaching a considerable speed, the transmission is engaged in the gear, and then the clutch pedal is quickly released and refueled. Once the engine is started, the clutch pedal should be quickly depressed, and the throttle should be controlled to prevent the engine from shutting off and then slowly stopping.
The method and principle of traction and traction start is similar to that of the cart, but it is less labor-saving than it is. The specific implementation of the use of a suitable length of the traction rope, and the two tied solid. Before traction, front and rear drivers should confirm the contact signal, such as whistle or gesture, in order to coordinate. To start slowly, the driver in front of the vehicle should pay attention to the traffic conditions on the road. After the start of the vehicle, the driver of the rear vehicle should promptly indicate that the vehicle should be in front of the vehicle. The two vehicles should be slowly approaching the on-street parking.
There are many kinds of FRP profiles, such as FRP round pipe, FRP square pipe, FRP rectangular pipe, FRP round bar and FRP i-bar.
The basic components of FRP profile are resin and glass fiber (including cloth, felt, etc.). It is reinforced with fiber (including glass fiber, carbon fiber, organic fiber and other metal, non-metal fiber) and resin (mainly epoxy resin).Polyester resins, phenolic resins) are composite of other auxiliary materials (main auxiliary materials: mold release agent, curing agent, catalyst, sealing agent, UV light stabilizer, mold cleaning water, gel coat, etc.).It has high temperature resistance, corrosion resistance, high strength, low specific gravity, low moisture absorption, small extension and good insulation and other excellent characteristics.
Fiberglass Round Tube,Frp Pultrusion Round Tube,Frp Round Hollow Tube,Frp Round Tube
Hebei Long Zhuo Trade Co., Ltd. , https://www.hblongzhuo.com